Below is the initial API configuration screen. Your screen may be a little different.
You will need to add us as a vendor, assign a token and add the IP address. We have been leaving the IP address blank or entering ALL or ANY. See which one works for you.
Next, allow us access to the following files (you may have them named differently):
Classes (Course and Class Section)
SchoolTool Configuration Page
• Just complete last section (indicated below in RED)
• Check the box to enable the API
• Enter a password in the Authentication Token box
The IP address field should be marked to '"any" or "all" or possibly left blank.
We used to set it to these IP Addresses: 184.108.40.206 and 220.127.116.11, but this didn't work for all the districts.